Hobart ML-104562 6460C Manual de usuario

FORM 37005 (Apr. 2006)MODEL 6430T, 6460 & 6460TPOTATO PEELERMODELML-137602 6430TML-19630 6460ML-137604 6460TML-104562 6460CML-137606 6460CT701 S.

– 10 –Turn on the water or disposer, if equipped, and thoroughly clean the interior of the hopper using a mildsoap and brush. Turn off the water or di

– 11 –TROUBLESHOOTINGSYMPTOM POSSIBLE CAUSEPeeler won't operate. Electrical power not connected.Circuit breaker tripped or fuse blown.Excessive f

– 12 –PL-56334INSTALLATION DIAGRAM (WITHOUT TRAP)

– 13 –PL-56333INSTALLATION DIAGRAM (WITH TRAP)

– 14 –PL-56335INSTALLATION DIAGRAM (DISPOSER STAND)

– 15 –NOTES

– 16 –NOTESFORM 37005 (Apr. 2006) PRINTED IN THE U.S.A.

– 2 –Installation, Operation and Care ofMODEL 6430, 6430T, 6460 & 6460T PEELERSSAVE THESE INSTRUCTIONSGENERALModels 6430 and 6430T Peelers are des

– 3 –PL-56337 DATA PLATEINLET TUBINGDISPOSER FLANGESWITCHHOPPER TOPBRACKET ASSEMBLYSCREWTUBE COUPLINGABRASIVE DISCJUNCTION BOX COVERADAPTERPLAT

– 4 –LEXAN LINER1. Slide the liner (Fig. 2) into the hopper, ensure the liner is under retaining brackets (Fig. 2) andresting on the top of the lip (F

– 5 –Assemble the legs as follows (Fig. 4):1. Lay the peel trap on its side.2. Assemble one of the rubber gaskets to one of the curved leg clamp bolts

– 6 –To position peel trapdrawer BENEATH thedischarge chute:To position peel trapdrawer to the RIGHTof discharge chute:To position peel trapdrawer to

– 7 –DISPOSER STANDIf a disposer stand is to be used, unpack the stand from its shipping carton. The feet may be threadedin or out as necessary to lev

– 8 –ELECTRICAL CONNECTIONSBefore making electrical connections, check the specifications on peeler data plate (Fig 1), as well asthose of the dispose

– 9 –OPERATIONUsing the lugs on the hopper top as locators, position the hopper top on the housing and turn itclockwise into place.Close and latch the