Hobart WS-80 Manual de usuario

WS-40/80 Hobart Compact WaterSoftener Installation InstructionsWS-40WS-80- NOTICE -This Manual is prepared for the use of trained Hobart Ser

DISC SELECTIONDISC SELECTION WS-40/80 The amount of hardness removed (in compensated gpg) will be based on the amount of brine and the meter discselec

TABLE OF CONTENTSINSTALLATION ... 3INSTALLATION WS-40/80 .

INSTALLATIONINSTALLATION WS-40/80SAVE THESE INSTRUCTIONS Disconnect theelectrical power to the machine andfollow lockout / tagout procedures.1. Locate

Fig. 59. Install one O-Ring into each groove of the brassadapter.Fig. 610. Apply a small amount of seal lube evenly ontoeach O-ring.Fig. 711. Remove t

15. Insert tubing provided into the overflow port onthe back of the softener and run drain lower thanthe cabinet connection to provide a gravity drain

Brine Valve SettingsUnit Brine SettingFloat CupHeightWS-40 1.0 lb. 6.25"WS-80 1.4 lb. 6.5"E. Reinstall brine valve into the cabinet.NOTE: D

Fig. 1727. Check for proper operation by pressing therecessed red button on bottom of salt alarmcontroller. If controller is operating properly - thei

DISC REPLACEMENTDISC REPLACEMENT WS-40/801. Remove screws and cap cover from level one.Fig. 192. Remove balance piston.Fig. 203. Remove balance piston

6. Install correct meter disc and reassemble inreverse order.NOTE: Be certain to start cap screws by hand rotatingbackwards until screw drops into th